Uneven heating of the two legs can cause distortion. Plan welding sequence, fixturing and heat input together.
Technical assessment
Uneven heating of the two legs can cause distortion. Plan welding sequence, fixturing and heat input together.
Practical example and verification method
For a long angle, consider a balanced welding sequence where permitted by the procedure rather than one continuous weld on one side. Record reference dimensions before welding and recheck angle and straightness under the same support conditions. Measure leg angle and longitudinal straightness before welding. Match weld locations and restraint points to the planned procedure. Repeat the same measurements after the first component has cooled; hot and cold readings are not directly equivalent. Do not restrict cleaning to the most visible weld face. If correction is necessary, use an agreed method rather than uncontrolled local heating, then inspect the component again.
Order information and decision limits
Provide weld length, position, base-metal grade and final surface requirements. Post-weld grinding should not unnecessarily thin the section; heat tint needs appropriate assessment and treatment.
Welding considerations for stainless steel angles
Uneven heating of the two legs can cause distortion. Plan welding sequence, fixturing and heat input together.
What should this enquiry include?
Provide weld length, position, base-metal grade and final surface requirements.
