Weight of stainless disks and rings cut from sheet
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

Weight of stainless disks and rings cut from sheet

Disk volume is π × diameter² / 4 × thickness.

Disk volume is π × diameter² / 4 × thickness.

Direct answer and application context

Disk volume is π × diameter² / 4 × thickness. For a ring, subtract the inside diameter squared from the outside diameter squared. With dimensions in millimetres and density in g/cm³, multiply volume by density and divide by 1,000,000 to obtain kilograms. This applies to a flat part of uniform thickness.

Ordering and fabrication checks

For example, a 304 ring with 200 mm outside diameter, 100 mm inside diameter and 3 mm thickness weighs about 0.56 kg. Cutting clearance and sheet nesting separately determine purchasing quantity. Bolt holes and chamfers reduce net mass. Actual dimensions and tolerances affect the result, so the estimate does not replace shipment weighing.

Purchased mass versus finished mass

A ring may weigh 0.56 kg while its source sheet also contains gaps between outside cuts and unused corners. Multiplying part mass by quantity gives finished net mass, not the complete purchasing requirement. Reusing the inner disks in another job can change overall material utilisation.

Can the ring inside diameter exceed the outside diameter?

No. Outside diameter must exceed inside diameter, and thickness must be positive.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗