Specifying equal-leg stainless steel angle
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

Specifying equal-leg stainless steel angle

40×40×4 means two 40 mm legs and 4 mm thickness. The inside radius makes actual area differ from an idealised calculation.

40×40×4 means two 40 mm legs and 4 mm thickness. The inside radius makes actual area differ from an idealised calculation.

Technical assessment

40×40×4 means two 40 mm legs and 4 mm thickness. The inside radius makes actual area differ from an idealised calculation.

Practical example and verification method

Do not shorten a 40×40×4 order to 40 mm angle. Changing thickness from 3 mm to 4 mm alters mass and connection geometry; the drawing and quotation line should both contain all three dimensions. Define both external leg dimensions and the thickness inspection location first. Clarify measurement points because production geometry can affect readings near the corner. Show bolt or weld areas on the section, then add length and angle tolerances separately. Inspect several locations on the first delivery against the quotation description; the overall appearance of the angle may not reveal a small but important thickness difference.

Order information and decision limits

List leg sizes, thickness, length and supply tolerance on the same enquiry line. Clarify external measurement conventions and manufacturing route with a drawing where necessary.

Specifying equal-leg stainless steel angle

40×40×4 means two 40 mm legs and 4 mm thickness. The inside radius makes actual area differ from an idealised calculation.

What should this enquiry include?

List leg sizes, thickness, length and supply tolerance on the same enquiry line.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗