Fit selection depends on load direction, rotation, temperature and disassembly requirements. Raw-stock tolerance may not equal the finished bearing-seat tolerance.
Technical assessment
Fit selection depends on load direction, rotation, temperature and disassembly requirements. Raw-stock tolerance may not equal the finished bearing-seat tolerance.
Practical example and verification method
Do not automatically assign the same fit to a rotating inner ring and another stationary ring. Find the manufacturer’s guidance for the load and temperature, then select raw stock around the required finished surface. Identify which ring rotates relative to the load and determine assembly temperature. Check the appropriate fit recommendation in the bearing catalogue. Note shaft shoulder, corner and roughness requirements as well as diameter. Select stock around that machining route. If the fit is too tight or loose, measure the actual shaft and housing together rather than simply trying a different bearing brand.
Order information and decision limits
Allow machining stock using the bearing manufacturer’s fit guidance and finished-surface requirements. Matching nominal bearing bore and shaft diameter does not ensure a clearance-free fit in every application.
Sizing stainless shafts for bearing seats
Fit selection depends on load direction, rotation, temperature and disassembly requirements. Raw-stock tolerance may not equal the finished bearing-seat tolerance.
What should this enquiry include?
Allow machining stock using the bearing manufacturer’s fit guidance and finished-surface requirements.
