Selecting stainless sheet for press-brake bending
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

Selecting stainless sheet for press-brake bending

Cracking risk and springback depend on material condition, thickness, bend orientation and tooling geometry as well as grade.

Cracking risk and springback depend on material condition, thickness, bend orientation and tooling geometry as well as grade.

Direct answer and application context

Cracking risk and springback depend on material condition, thickness, bend orientation and tooling geometry as well as grade. A single bend-radius rule does not apply to every stainless sheet. Trials with the intended machine and tooling may be needed to establish final dimensions. Tool marks also deserve separate attention on visible surfaces.

Ordering and fabrication checks

Separate blank dimensions from finished dimensions and state the inside radius, angular tolerance and visible face. Discuss protective film or appropriate tool protection. Very short flanges and holes close to a bend can affect manufacturability. Verify the sample part in its intended assembly before committing to series production.

A trial for springback

For a finished ninety-degree bend, the machine setting depends partly on springback. The same setup should not be assumed to produce identical results on every batch or thickness. Measure the trial angle after unloading so the position under machine force is not mistaken for the final component angle.

Can one bend radius be specified for every sheet?

No. Grade, material condition, thickness and tooling geometry need assessment together.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗