Round versus square stainless steel bar
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

Round versus square stainless steel bar

Round-section area is πd²/4, whereas square-section area is a²; equal numerical dimensions do not mean equal weight.

Round-section area is πd²/4, whereas square-section area is a²; equal numerical dimensions do not mean equal weight.

Technical assessment

Round-section area is πd²/4, whereas square-section area is a²; equal numerical dimensions do not mean equal weight.

Practical example and verification method

A 20 mm round section has approximately 314 mm² area; a 20 mm square has 400 mm². At equal length the square stock is approximately 27 percent heavier; compare the remaining section after machining separately. Start by drawing the smallest stock section that contains the finished component. If square faces will be machined from round stock, all corners must lie within the circle; the finished face width is not the required stock diameter. Next define workholding faces and operation sequence. Compare chip volume using this geometry, then compare the extra operations and cycle time for the same batch quantity.

Order information and decision limits

For turning, specify finished diameter; for milling, state the minimum corner and face allowances. Choosing only by price per kilogram can increase chip loss and machining time.

Round versus square stainless steel bar

Round-section area is πd²/4, whereas square-section area is a²; equal numerical dimensions do not mean equal weight.

What should this enquiry include?

For turning, specify finished diameter; for milling, state the minimum corner and face allowances.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗