Preventing iron contamination on stainless hollow sections
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

Preventing iron contamination on stainless hollow sections

A grinding disc previously used on carbon steel or a contaminated bench can transfer iron particles to stainless sections.

A grinding disc previously used on carbon steel or a contaminated bench can transfer iron particles to stainless sections.

Technical considerations

A grinding disc previously used on carbon steel or a contaminated bench can transfer iron particles to stainless sections. Rust marks developing later may then be mistaken for a failure of the base stainless material. Dedicated or suitably cleaned tools, controlled storage and sensible workshop separation help reduce the risk. Scraping a stain with carbon-steel wire can add fresh contamination. Choose cleaning methods from the finish and the cause of staining. Deep or recurring marks call for investigation of contamination and possible corrosion rather than cosmetic cleaning alone.

Remove the contamination source

A cleaned section placed back on the same dirty bench can become contaminated again. Review cutting, grinding, storage and packaging points through the workflow. Cloths and gloves can also transfer debris. Inspection should not focus only on the final bright face; plan a suitable check for marks that may become visible only after protective film is removed.

Does removing a stain end the investigation?

Recurring staining calls for review of the contamination source and surface condition.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗