A cutting plan adds saw kerf and end-trimming allowances to each part length. The yield from one stock length follows from this total.
Technical assessment
A cutting plan adds saw kerf and end-trimming allowances to each part length. The yield from one stock length follows from this total.
Practical example and verification method
For 6000 mm of usable stock, 495 mm blanks with an assumed 3 mm kerf consume 498 mm each. Excluding end trimming, twelve blanks fit; record the remainder for a later order. First subtract unusable ends from actual stock length. Add kerf to each blank length and calculate the whole-number yield. Grouping identical lengths may reduce setup changes. For a mixed cutting list, match remaining offcuts to later items rather than discarding them automatically. After the first production cuts, measure actual kerf and update the plan; do not assume the original estimate remains accurate throughout the order.
Order information and decision limits
Provide required part quantity, finished length and acceptable cutting tolerance together. Assuming the whole stock length is usable can leave the final blank too short.
Planning cut lengths and yield for stainless bar
A cutting plan adds saw kerf and end-trimming allowances to each part length. The yield from one stock length follows from this total.
What should this enquiry include?
Provide required part quantity, finished length and acceptable cutting tolerance together.
