For a round tube with outside diameter D and wall thickness t, the nominal bore is D−2t.
Technical considerations
For a round tube with outside diameter D and wall thickness t, the nominal bore is D−2t. A 40 mm outside diameter with a 2 mm wall therefore gives a nominal 36 mm bore. Manufacturing tolerances and the internal weld profile can still affect the measured clearance. A clamp fitted around the tube depends on the outside diameter, whereas a shaft inserted into it depends on the usable internal space. Label the dimension explicitly on the drawing. Ordering a “40 pipe” without identifying the measurement system can produce a mismatch even when both parties believe they understand the size.
Check an inserted component
Do not assume a 36 mm component will slide freely into a nominal 36 mm bore. Component tolerance, tube tolerance and the internal seam can combine. Define the minimum assembly clearance on the drawing and check several locations for a long insert. Measure a sound cross-section rather than a burred end that may distort the reading.
Is the bore identical everywhere?
It is nominally defined; tolerances and manufacturing details can affect the measured clearance.
