Leg width, thickness, included angle and longitudinal straightness are separate inspection characteristics. The inside radius can affect caliper contact.
Technical assessment
Leg width, thickness, included angle and longitudinal straightness are separate inspection characteristics. The inside radius can affect caliper contact.
Practical example and verification method
When measuring both legs, ensure caliper jaws do not contact a burr or corner radius. Recording start, middle and end positions reveals local variation; the method must remain consistent with the acceptance requirement. Identify flat contact areas for the measuring instrument. Deal with end burrs using the agreed method before measurement, since they can overstate leg thickness. Repeat measurements at consistent locations and record variation. Check included angle separately from thickness. For borderline results, verify instrument suitability and technique before declaring compliance or rejection; recorded positions and readings make discussion with the supplier much clearer.
Order information and decision limits
Define measurement locations and acceptance tolerances together with the applicable product standard. A measurement at one end does not establish uniform geometry along the full length.
Measuring dimensions and angles of stainless angle stock
Leg width, thickness, included angle and longitudinal straightness are separate inspection characteristics. The inside radius can affect caliper contact.
What should this enquiry include?
Define measurement locations and acceptance tolerances together with the applicable product standard.
