Machining and cutting allowances for stainless shaft orders
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

Machining and cutting allowances for stainless shaft orders

Treat machining allowance separately as extra stock diameter and extra cut length beyond finished dimensions.

Treat machining allowance separately as extra stock diameter and extra cut length beyond finished dimensions.

Technical assessment

Treat machining allowance separately as extra stock diameter and extra cut length beyond finished dimensions.

Practical example and verification method

Raw stock for a finished 25 mm shaft must leave cleanup allowance even at its lower diameter limit. Calculate length allowance separately; sufficient diameter stock does not establish that enough length remains for facing. Obtain the lower and upper limits of the supplied diameter first. Check that the lower limit still leaves enough material to clean the entire surface. Add facing allowances at both ends and any clamping loss to the length calculation. If stock is bent, diameter difference alone is not the available cleanup allowance. Measuring actual removal on a sample helps avoid selecting unnecessarily oversized stock.

Order information and decision limits

Specify minimum stock removal, facing allowance and workholding needs. Excessive allowance increases machining time and tool consumption as well as material cost.

Machining and cutting allowances for stainless shaft orders

Treat machining allowance separately as extra stock diameter and extra cut length beyond finished dimensions.

What should this enquiry include?

Specify minimum stock removal, facing allowance and workholding needs.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗