Ground versus drawn stainless shaft stock
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

Ground versus drawn stainless shaft stock

Drawing is a forming process, whereas grinding removes material to control size and surface. The two terms do not describe the same supply condition.

Drawing is a forming process, whereas grinding removes material to control size and surface. The two terms do not describe the same supply condition.

Technical assessment

Drawing is a forming process, whereas grinding removes material to control size and surface. The two terms do not describe the same supply condition.

Practical example and verification method

Even if drawn stock appears adequate for a seal surface, check the finished roughness requirement. Plan final grinding where needed and ensure that the remaining diameter stays within tolerance after the operation. First identify the function of the final surface: bearing fit, sealing and appearance have different requirements. Measure the current stock at several positions. Check whether planned grinding cleans the whole surface without exceeding the lower size limit. Where straightness matters, inspect it before and after grinding. Match the grinding process to the grade; making a surface shiny does not automatically correct dimensional or form errors.

Order information and decision limits

For bearing and seal surfaces, specify required roughness as well as diameter tolerance. A ground finish alone does not guarantee specified straightness, hardness or corrosion performance.

Ground versus drawn stainless shaft stock

Drawing is a forming process, whereas grinding removes material to control size and surface. The two terms do not describe the same supply condition.

What should this enquiry include?

For bearing and seal surfaces, specify required roughness as well as diameter tolerance.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗