Flow area and bore calculation for stainless pipe
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

Flow area and bore calculation for stainless pipe

Pipe bore area varies with the square of internal diameter: A=π×d²/4.

Pipe bore area varies with the square of internal diameter: A=π×d²/4.

Technical considerations

Pipe bore area varies with the square of internal diameter: A=π×d²/4. A 40 mm bore gives an area of about 1,256.6 mm². At a fixed outside diameter, increasing wall thickness reduces this available area. Area helps relate flow rate to mean velocity, but a pressure-loss calculation also requires fluid properties, line length, roughness and local losses at fittings. Internal weld reinforcement or a restricted fitting can limit the actual passage. A design calculation should consider manufacturing tolerances as well as nominal dimensions.

Keep flow calculation units consistent

Using flow rate in m³/s and area in m² gives mean velocity in m/s. Failing to convert square millimetres to square metres creates a factor-of-one-million error. Check the smallest passage along the line because a valve or fitting may be narrower than the pipe. Where density or viscosity changes, use fluid data at the operating temperature.

Does bore area alone determine flow rate?

No. Velocity or the system pressure and loss information is also needed.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗