Estimating cutting loss for short stainless tube parts
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

Estimating cutting loss for short stainless tube parts

Every saw kerf and initial end trim adds to the material required for short tube parts.

Every saw kerf and initial end trim adds to the material required for short tube parts.

Technical considerations

Every saw kerf and initial end trim adds to the material required for short tube parts. Ten 500 mm pieces may therefore need more than 5,000 mm of stock. The cutting sequence, end preparation and minimum useful remnant length should be recorded separately. Nesting several different part lengths into one stock tube can reduce scrap, but damaged or dented ends must not be counted as usable material. A quotation should identify finished piece count, length tolerance and whether remaining offcuts are to be returned with the order.

Base nesting on the real cutting process

Do not assume a 6,000 mm stock length yields twelve finished 500 mm pieces without considering kerf. Each cut consumes material, and end trimming may also be required. Do not use the length tolerance arbitrarily to hide inadequate stock allowance. Build the plan from finished dimensions and agreed process allowances, then list usable remnants separately from scrap.

Is scrap only the final offcut?

No. Kerfs and required trimming allowances also contribute to total loss.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗