End caps and drainage details for stainless hollow sections
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

End caps and drainage details for stainless hollow sections

Closing a hollow-section end is not just an appearance decision.

Closing a hollow-section end is not just an appearance decision.

Technical considerations

Closing a hollow-section end is not just an appearance decision. Drainage, ventilation, cleaning access and the requirements of welding need separate consideration. Heating a fully enclosed volume raises fabrication safety concerns and requires an appropriate procedure. Locate a drain opening from the actual installed orientation; the face drawn at the bottom may not be the lowest face on site. Any hole in a load-bearing member also needs assessment for its structural effect. Cap material and fixing method should be compatible with the service environment.

Match drainage to installed orientation

A member lying horizontally in the workshop may be installed on a slope or vertically. Confirm the drain works in that final position. A washer or covering added during installation can block an otherwise sensible opening. Review closures and ventilation with the full fabrication sequence, including welding safety, rather than treating the drain as an isolated feature added at the end.

Does a closed section exclude water?

It depends on joints and closures; a closed appearance does not prove watertightness.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗