Drilling stainless angle and specifying edge distances
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

Drilling stainless angle and specifying edge distances

Define hole positions relative to the leg edge and inside radius. Check drill access and the fastener seating surface.

Define hole positions relative to the leg edge and inside radius. Check drill access and the fastener seating surface.

Technical assessment

Define hole positions relative to the leg edge and inside radius. Check drill access and the fastener seating surface.

Practical example and verification method

A bolt head positioned too close to the inside radius may not seat flat. Check washer diameter and tool access when setting the hole centre; correcting the conflict after drilling can be expensive. Place the actual bolt and washer geometry on the section first. Check space for a wrench or socket on the tightening side. Define how the drilling fixture will locate the part, then transfer centre spacings and hole tolerances to the drawing. For a load-bearing connection, have the designer verify edge distances and failure modes; the fact that it can be assembled does not prove mechanical adequacy.

Order information and decision limits

Show hole diameter, tolerance, centre spacing and deburring requirements on the drawing. For load-bearing joints, edge distances and hole patterns are not selected solely for assembly convenience.

Drilling stainless angle and specifying edge distances

Define hole positions relative to the leg edge and inside radius. Check drill access and the fastener seating surface.

What should this enquiry include?

Show hole diameter, tolerance, centre spacing and deburring requirements on the drawing.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗