Contact between a round collet and hexagon stock can be limited. A suitable shaped collet or soft jaws can improve workholding stability.
Technical assessment
Contact between a round collet and hexagon stock can be limited. A suitable shaped collet or soft jaws can improve workholding stability.
Practical example and verification method
If a closing collet contacts only the corners, the stock may not be properly supported. Use the size and shape recommended by the workholding supplier and follow safe setup and inspection procedures rather than informal hand testing. Check the machine and workholding manufacturer’s provisions for hexagon stock first. Compare a correctly shaped collet’s operating range with stock tolerance. Remove chips or burrs from contact areas. Inspect stick-out and witness marks using the safe setup procedure. Reassess workholding if cutting loads change: applying more clamping force is not a universal remedy and may deform the component rather than improve the setup.
Order information and decision limits
Review across-flats tolerance, stick-out and permissible marking as part of machine setup. Set machining parameters within the safety limits specified by machine and workholding manufacturers.
Collet and jaw selection for stainless hexagon bar
Contact between a round collet and hexagon stock can be limited. A suitable shaped collet or soft jaws can improve workholding stability.
What should this enquiry include?
Review across-flats tolerance, stick-out and permissible marking as part of machine setup.
