Cold drawing can change dimensional control and surface appearance; annealed and cold-worked supply conditions are not mechanically identical.
Technical assessment
Cold drawing can change dimensional control and surface appearance; annealed and cold-worked supply conditions are not mechanically identical.
Practical example and verification method
For stock intended for a precision seat, first write down the finished diameter range. Then compare measured diameters and proposed machining allowances for drawn and rolled alternatives, recording the supply condition. First obtain a written supply-condition description: manufacturing route and annealing condition can be separate information. Measure diameter and inspect the surface at several sample locations. Compare those findings with the allowance needed for the finished component. Include any additional grinding or straightening in the total quotation comparison. Where mechanical properties matter, use the applicable product requirements and documentation instead of drawing conclusions from appearance.
Order information and decision limits
Specify manufacturing route, supply condition and applicable tolerance standard together. A bright surface alone does not prove compliance with a particular tolerance class.
Cold-drawn versus hot-rolled stainless bar
Cold drawing can change dimensional control and surface appearance; annealed and cold-worked supply conditions are not mechanically identical.
What should this enquiry include?
Specify manufacturing route, supply condition and applicable tolerance standard together.
