Roughness, lay direction, hardness and diameter tolerance all matter at a sealing surface. Sharp machining marks can influence seal behaviour.
Technical assessment
Roughness, lay direction, hardness and diameter tolerance all matter at a sealing surface. Sharp machining marks can influence seal behaviour.
Practical example and verification method
Even at the correct diameter, helical turning marks can influence fluid transport. When investigating leakage, inspect lay direction, surface condition and the machining method permitted by the seal supplier rather than measuring diameter alone. Identify the seal model and its manufacturer’s shaft-surface requirements first. Measure diameter along the working track, not at one section only. Where roughness is measured, match measurement direction and instrument settings to the specification. Record machining lay separately. If leakage continues, inspect alignment, fluid and seal damage as well; attributing every leak to shaft material can delay identification of the actual cause.
Order information and decision limits
State seal material, working fluid, surface speed and the seal manufacturer’s surface requirements. A shinier-looking surface is not necessarily a better sealing surface.
Choosing stainless shaft surfaces for seals
Roughness, lay direction, hardness and diameter tolerance all matter at a sealing surface. Sharp machining marks can influence seal behaviour.
What should this enquiry include?
State seal material, working fluid, surface speed and the seal manufacturer’s surface requirements.
