Checking dimensions and finish when stainless tube arrives
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

Checking dimensions and finish when stainless tube arrives

Receiving inspection starts by matching the quotation line to the material identification.

Receiving inspection starts by matching the quotation line to the material identification.

Technical considerations

Receiving inspection starts by matching the quotation line to the material identification. Measure outside diameter in more than one direction, check the wall with a suitable method and assess length against the stated tolerance. Ovality, straightness, dented ends and scratches matter differently depending on the intended use. Measuring a small sample does not mean the entire batch has been inspected; agree the sampling approach in advance. Instrument resolution and calibration should suit the specified tolerances. If documentation was requested, also verify the grade designation and its link to the delivered batch.

Describe discrepancies with measurement records

When reporting a dimensional discrepancy, record the instrument, location, direction and relevant temperature conditions. A burred end may measure differently from a sound middle section. One caliper reading in a photograph should not determine the status of an entire batch. Review the same acceptance document with the supplier and segregate doubtful material before it enters fabrication.

Does one measurement verify the whole batch?

No. Inspection scope and the sampling plan should be agreed in advance.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗