Burrs left after cutting or drilling can interfere with assembly, handling and contact surfaces.
Direct answer and technical context
Burrs left after cutting or drilling can interfere with assembly, handling and contact surfaces. Deburring and machining a dimensioned chamfer are different operations. Lightly breaking an edge may not satisfy a drawing requiring a chamfer with a specified angle and width.
Application and purchasing checks
Identify the edges to be treated on the drawing. For visible parts, check that the edge texture suits the broad face. Clean abrasives dedicated to stainless reduce contamination risk. Assess dimensional loss and thin-edge formation after processing; reducing sharpness alone may not meet every acceptance requirement.
Practical example and checkpoint
Burrs around a hole can prevent flat mating faces from seating correctly. A neat outside edge does not solve that problem. Inspect both faces of holes and the contact surfaces. For chamfered holes, the drawing should distinguish the chamfered opening from the nominal bore dimension.
Are deburring and a dimensioned chamfer the same?
No. A chamfer can require a specified size and angle; define the scope on the drawing.
