For a solid round section, mass increases with the square of diameter; doubling diameter quadruples theoretical weight at the same length.
Technical assessment
For a solid round section, mass increases with the square of diameter; doubling diameter quadruples theoretical weight at the same length.
Practical example and verification method
A 30 mm diameter, 2 m raw shaft weighs approximately 11.21 kg. If part is turned to 20 mm, calculate the two cylinder volumes separately; using the larger diameter throughout overstates finished mass. Divide the shaft into constant-diameter segments. Calculate each volume from its diameter and length, multiply by the appropriate density and subtract bores or grooves separately. Avoid counting overlapping regions twice. State whether small chamfers and radii are excluded from the approximation. If the result is used for handling or packaging, weighing the first finished component provides a useful check on the calculation method.
Order information and decision limits
A 30 mm diameter, 1 m long 304 shaft weighs approximately 5.61 kg, using density 7.93 g/cm³. Keyways, bores and turned-down regions mean a raw-shaft calculation does not give finished-part weight.
Calculating stainless shaft weight from diameter
For a solid round section, mass increases with the square of diameter; doubling diameter quadruples theoretical weight at the same length.
What should this enquiry include?
A 30 mm diameter, 1 m long 304 shaft weighs approximately 5.61 kg, using density 7.93 g/cm³.
