Bend radius and springback matter for sheet-formed angles; rolled-section corner geometry depends on the production route.
Technical assessment
Bend radius and springback matter for sheet-formed angles; rolled-section corner geometry depends on the production route.
Practical example and verification method
For an angle fitting over a hollow-section corner, its inside bend radius matters. Matching leg dimensions and thickness can still leave a corner gap; check contact faces using a section sketch. Obtain the mating component’s external corner geometry too. Overlay both sections at the same scale to identify contact and clearance regions. Specify any required welding or adhesive gap separately. If a sample does not fit, review tolerances and production route instead of forcing it into place. Closing a gap by assembly force can introduce residual stress or surface marks; external appearance alone is not a fit assessment.
Order information and decision limits
For mating parts, provide inside-radius and leg-angle tolerances. Equal external dimensions from two production routes may not produce the same corner fit.
Bent versus rolled stainless steel angle
Bend radius and springback matter for sheet-formed angles; rolled-section corner geometry depends on the production route.
What should this enquiry include?
For mating parts, provide inside-radius and leg-angle tolerances.
