Batch cutting and piece-count planning for hexagon bar
ÖZCAN PASLANMAZ · EST. 2002
+90 212 549 27 09[email protected]

Batch cutting and piece-count planning for hexagon bar

Allow saw kerf and facing stock for each blank. Small allowances materially affect total yield when piece quantities increase.

Allow saw kerf and facing stock for each blank. Small allowances materially affect total yield when piece quantities increase.

Technical assessment

Allow saw kerf and facing stock for each blank. Small allowances materially affect total yield when piece quantities increase.

Practical example and verification method

A usable 3000 mm length theoretically yields sixty 48 mm blanks with 2 mm kerf each. If end trimming or a clamping remnant is required, reduce usable length first and recalculate the count. Establish whether usable length differs from total stock length. Do not subtract kerf only once from the entire length: every separation consumes material. Round the calculated yield down to whole pieces. Check the remnant needed to hold the final blank on the actual machine. Record achieved quantity and remaining stock after the first batch, then use that verified information to improve the next cutting plan.

Order information and decision limits

List net quantity, blank length, tolerance and deburring requirements together. A theoretical count derived from kilograms is not the deliverable quantity until kerf and unusable ends are deducted.

Batch cutting and piece-count planning for hexagon bar

Allow saw kerf and facing stock for each blank. Small allowances materially affect total yield when piece quantities increase.

What should this enquiry include?

List net quantity, blank length, tolerance and deburring requirements together.

Share the material, grade, dimensions and quantity so our sales team can assess your request.

Request a Quote
WhatsApp ↗