Guillotine-cut edge quality depends on thickness, shear settings, blade condition and material properties.
Direct answer and application context
Guillotine-cut edge quality depends on thickness, shear settings, blade condition and material properties. A cut edge is not automatically safe to handle or touch in service, so burrs require attention. Narrow strips may also develop bow or twist. The required finished edge should inform the choice of cutting process.
Ordering and fabrication checks
State finished dimensions, quantities and whether the edges remain visible. Explicitly request deburring or edge breaking when needed. For close-fitting assemblies, check dimensional tolerance and squareness. When comparing laser and shear quotations, include any later straightening and finishing work rather than considering the cutting charge alone.
The edge’s next operation
For a sheared strip that will be welded, joint preparation matters; for a touch surface, burrs and edge safety matter. The same cut edge can therefore have different acceptance requirements in two applications. Use a drawing to identify the required result rather than an ambiguous request to finish all edges.
Is a sheared edge automatically a finished edge?
Not necessarily. Check burrs, squareness, appearance and subsequent processing requirements.
